Precautions On Adjusting; Adjusting Connectors; Connecting The Equipment - Sony CCD-TRV138 Manual

3-1-2.

Precautions on Adjusting

This set is adjusted in two modes, VTR mode and CAMERA mode.

3-1-3. Adjusting Connectors

Some of the adjusting points of the video section are concentrated
at VC-341 board CN007. Connect the measuring instruments via
I/F unit for LANC control (J-6082-521-A) and CPC jig connector
(J-6082-539-A).
The following table shows the pin No. and signal name of CN007.
Pin No. Signal Name
1 EEP SCK
2 PB RF
3 BPF MONI
4 CAP FG
5 SWP DIR
6 REG GND
7 REC RF
8 REG GND
Table 6-3-1

3-1-4. Connecting the Equipment

Connect the measuring instruments as shown in Fig. 6-3-1 and
perform the adjustments.
Connecting the TV Monitor and Adjustment Remote Commander
Note: Use either the AC power adaptor or the InfoLITHIUM battery as the power supply of I/F unit for LANC control.
L serices Info
LITHIUM battery (7.2Vdc)
LANC jack
Adjustment
remote commander (RM-95)
CCD-TRV138/TRV238E/TRV338/TRV438E
Pin No. Signal Name
9 PB RF
10 REG GND
11 LANC OUT
12 LANC IN
13 XLANC PWR ON
14 EEP SO
15 EEP SI
16 XCS EEP
CPC lid
Screw (M2)
AC adaptor
I/F unit for LANC control
(J-6082-521-A)
The following table lists the test point of I/F unit of for LANC
control.
Pin No. Signal Name
BL
14 EVF VG
9 PB RF (MON)
3 BPF MONI
TMS
TDI
5 SWP
4 CAP FG
Note: Pin No. are those of CN007.
CN007
1
16
Video (yellow)
AC IN
Conductor side
CPC jig connector
(J-6082-539-A)
Fig. 6-3-1
6-26
Pin No. Signal Name
15 EVF VCO
BL 4.75
6, 8, 10 GND
7 REC RF (RF IN)
TDO
TCK
2 IR VIDEO
Table 6-3-2
A/V OUT jack
Audio (black)
TV monitor
AC adaptor
AC IN