Table of Contents
Advertisement
Replacement,
SmartSupply
variant CAB
Establishing
The SmartSupply in variant CAB does not have a battery and is supplied with voltage (12
the cable con-
- 24 V DC) via the power source of the industrial truck. The connection is established by
nection for
means of an additional M12 5-pin connector.
variant CAB
1.
Ensure that both plug connections are clean.
Fig. 11: Power supply, SmartSupply variant CAB
1
Connection, M12 5 V connector
2
Cable tie
3
M12 5-pin socket of the power source
4
Connection, M8 4-pin connector
2.
Establish the plug connection between the socket of the power source (Fig. 11/3)
and the plug of the SmartSupply (Fig. 11/1).
3.
Fix the plug connection in place on the housing using cable ties (Fig. 11/2). To do
so, guide the cable ties through the two openings in the housing.
Analogous steps!
For disassembly and assembly of the SmartSupply variant CAB, the
same steps as those for the SmartSupply variant BAT need to be carried
out for the most part. The additional cable connection for variant CAB is
one difference however.
®
SmartFork
SmartSupply
Maintenance
Replacement of the SmartSupply
23
EN
Advertisement
Table of Contents
