MSI MS-7236 Manual page 54

MS-7236 ATX Mainboard
Re-Call VGA BIOS from S3
When ACPI Standby State is set to [S3/STR], users can select the options in this
field. Selecting [Yes] allows BIOS to call VGABIOS to initialize the VGA card when
system wakes up (resumes) from S3 sleep state. The system resume time is short-
ened when you disable the function, but system will need an AGP driver to initialize
the VGA card. Therefore, if the AGP driver of the card does not support the initializa-
tion feature, the display may work abnormally or not function after resuming from S3.
Options: [Auto], [Yes], [No].
Suspend Time Out
If system activity is not detected for the length of time specified in this field, all
devices except CPU will be shut off. Settings: [Disabled], [1min], [2min], [4min], [8min],
[10min], [20min], [30min], [40min], [50min], [60min].
Power Button Mode
This feature allows users to configure the Power Button function. Settings are:
[On/ Off]
[Suspend]
Restore on AC Power Loss
This setting specifies whether your system will reboot after a power failure or
interrupt occurs. Available settings are:
[Power Off]
[Power On]
[Last State]
Wakeup Event Setup
Press <Enter> to enter sub-menu and the following screen appears.
USB Device Wake-Up from S3
This setting allows USB device wake up the system from S3 state. Settings are:
[Enable], [Disabled].
Keyboard Wakeup
The item specifies how the system will be awakened from power saving mode
when input signal of the keyboard is detected. Setting options: [Disabled], [Specific
Key], [Any Key].
3-16
The power button functions as a normal power-on/-off
button.
When you press the power button, the computer enters
the suspend/sleep mode, but if the button is pressed for
more than four seconds, the computer is turned off.
Leaves the computer in the power off state.
Leaves the computer in the power on state.
Restores the system to the previous status before power
failure or interrupt occurred.