Table of Contents
Advertisement
www.ffv.com
CHASE MODE
-
ON – the playback channel "chases" the record channel with a set time-shifted value defined in the "Chase
Delay" menu. IMPORTANT: For playback to start automatically when the Chase Delay value is reached, you
must first cue the playback channel by pressing the REW button (#17, Figure 4, page 14) and then press the
PLAY button (#13, Fig. 4).
-
OFF - the "Chase" mode is not active and the playback channel obeys front panel controls or remote control
commands sent to the rear panel's "RS-422" connector (see REAR PANEL CONNECTIONS on page 10).
A. Press the Menu button (#13, Figure 4, page 14).
B. Highlight the "Chase" Option using the scroll wheel (#19, Fig. 4).
C. Press the selection button (#14, Fig. 4) and ON/Off will be displayed.
D. Highlight the desired state using the scroll wheel (#19, Fig. 4).
E. Press the selection button (#14, Fig. 4) to turn "ON" or "OFF" the Chase mode.
Warning! In Chase Mode for playback to be smooth and accurate, the "REF. IN" signal and the SDI source input signal must be gen-locked to the same video master clock.
V 1.0 July 2015 MP
Preliminary Version subject to change without prior notice
16
Advertisement
Table of Contents
