Room humidity and temperature sensors (+/- 2 %), on-wall, calibratable, with active ⁄ passive output (20 pages)
Summary of Contents for domat THERMASGARD ETF 7
Page 1
P S - P R O T E C T I O N P ERF EC T S E N S O R P R O T EC T I O N Domat Control System s.r.o. U Panasonicu 376 530 06 Pardubice-Stare Civice CZ Česká...
Obecné informace Měřicí princip teplotních čidel pro VVK (obecně): Princip měření u teplotních senzorů spočívá v měření změny teplotně závislého odporu vnitřního prvku. Typ vnitřního senzoru určuje výstupní signál. Typy aktivních ⁄ pasivních teplotních sensorů jsou: a) Pt 100 (podle DIN EN 60 751) b) Pt 1000 (podle DIN EN 60751) c) Ni 1000 (podle DIN EN 43 760, TCR=6180 ppm ⁄...
Page 6
Montáž a uvádění do provozu Při připojování musí být zařízení bez napětí. Přístroje mohou být připojeny Před instalací se ujistěte, že technické parametry daného teploměru nejsou v rozporu s aktuálními podmínkami v místě měření, především: pouze k bezpečnému nízkému napětí. Následné škody způsobené –...
THERMASGARD ® ETF 7 Rev. 2020 - V15 Very quickly responding screw-in resistance thermometer ⁄ immersion temperature sensor 1x two-wire connection ® THERMASGARD ETF 7 with passive output, neck tube and a single-tapered stainless steel protective Standard tube, housing cover with quick-locking screws, very short reaction time, particularly suitable for very quick temperature changes and control operations, e.g.
Page 9
General notes Measuring principle of HVAC temperature sensors in general: The measuring principle of temperature sensors is based on an internal sensor that outputs a temperature-dependent resistance signal. The type of the internal sensor determines the output signal. The following active ⁄ passive temperature sensors are distinguished: a) Pt 100 measuring resistor (according to DIN EN 60 751) b) Pt 1000 measuring resistor (according to DIN EN 60751) c) Ni 1000 measuring resistor (according to DIN EN 43 760, TCR = 6180 ppm ⁄...
Page 10
Installation and Commissioning Devices are to be connected under dead-voltage condition. Devices must Before mounting, make sure that the existing thermometer‘s technical parameters comply with the actual conditions at the place of utilization, only be connected to safety extra-low voltage. Consequential damages in particular in respect of: caused by a fault in this device are excluded from warranty or liability.
Need help?
Do you have a question about the THERMASGARD ETF 7 and is the answer not in the manual?
Questions and answers