General Notes; Troubleshooting - ProKlima SPLIT 850 C Operating Instructions Manual

Anleitung SPLIT_850_C_GB:_

9. General notes

Problem
After pressing the start key the device is not started
by the microprocessor for 3 minutes.
Crackling noises can be heard.
There is an odd smell in the room.
You can hear moving water.
Care precautions
If the air conditioner is not going to be used for some
period of time:
1. Let the fans run for 3 - 4 hours to allow the device
to completely dry out. Set the highest possible
temperature level while the fans are running.
2. Switch off the device and pull the power plug.
Important:
Always pull out the power plug if the device is not
going to be used for some time. Collections of dust
pose a fire hazard.
3. Take the batteries out of the remote control.

10. Troubleshooting

Device does not start. Check the following:
1. Is voltage present at the plug socket outlet?
2. Check the plug fuse!
3. Is the timer set?
The device does not provide satisfactory cooling!
Check the following:
1. Has an appropriate temperature been set?
2. Is the air filter soiled? Clean and fit back in place.
3. Are the inlets and outlets on the outdoor device
blocked?
12
10.11.2006 8:24 Uhr Seite 12
This is not a fault, it is for the protection of the
compressor. Please have a little patience.
This is not a fault.
These tension noises are caused by the contraction
and expansion of the front panel in response to
temperature differences.
This is not a fault.
The air conditioner also circulates the transpiration
from the walls, carpets, smoke, furniture and clothing
in the air.
This is not a fault. The coolant in the air conditioner
may have expanded.
4. Has the sleep mode been set during the day?
5. Are the connections between the indoor and
outdoor device adequately sealed? There may not
be enough coolant? If so, please contact your
service company.
The remote control does not work!
(Important! It only works within a range of 8 m
from the indoor device.)
1. Are the batteries still OK? Replace if necessary!
2. Have the batteries been inserted correctly? Check
that the + and – terminals are correct!
In the event of a power failure, check the
following:
Press the ON/OFF key after a power failure.
If the problems remain after checking through the
above points, switch off the device and contact your
service company.
Cause