4Ddoors CX1024 Instructions For Fitting, Operating And Maintenance page 8

ENGLISH
2
50 mm
70mm
Figure 2 - Ground anchor
Note
The foundation must be allowed to harden suffi ciently before
installation.
4.2.3 Fixing the motor base plate to an existing
concrete foundation
Before drilling the four holes, their position must be marked on
the surface of the foundation. Use the motor base plate as a
drilling pattern. Always observe the installation dimensions! See
"Figure 1 - Foundation" and "Figure 2 - Ground anchor".
Then drill plug holes, clean the holes and fi x the base plate with
suitable installation materials. Ensure to tighten the nut and
washer to the ground.
ATTENTION!
Damage from dirt
Drilling dust and chips can lead to malfunctions.
►
Cover the opener when drilling.
A
8
3
D
E
4.2.4 Opening the opener housing
The cover of the housing must be opened for the sliding opener
to be installed.
Potential damage from penetrating moisture!
Protect the control from moisture when opening the sliding
►
opener.
+ X
m
0 m
1 0
X
Figure 3 - Heavy load anchor
ATTENTION!
Ø M10