4Ddoors CX1024 Instructions For Fitting, Operating And Maintenance page 39

J1-J4 Command input (START) for key switch, push button
(fl oating normally open contact)
J2-J4 Command input (START P) for partial opening
(fl oating normally open contact)
J3-J4 STOP input (fl oating normally closed contact)
J4 Common earth/ground (GND)
J5-J9 Light barrier type 1 (fl oating normally closed contact),
active in open and close direction
J6-J9 Light barrier type 2 (fl oating normally closed contact),
active in close direction
J7-J9 Contact strip OPEN (8k2 or fl oating normally closed
contact)
J8-J9 Contact strip CLOSE (8k2 or fl oating normally closed
contact)
J9 Common earth/ground (GND)
E1 Voltage output 24 V DC, max. 400 mA
E2 Voltage output, earth/ground (GND)
E3 Voltage output 24 V DC for function test; deactivated
for test
39
E4-E5 Warning light connection 24 V DC/max. 3 W
L L1 of mains supply 230 V AC/50 Hz
N N of mains supply 230 V AC/50 Hz
B1-B2 Lighting (fl oating option relay)
F1 Microfuse 2 A (safeguard for 230 V AC circuit)
MAINS Operating LED, lights up when voltage present
OVERLOAD Overload indicator for 24 V AC output, lights up on
overload
ADI ADI interface for additional modules
 "Up" function button or START
OK OK function button
"Down" function button or START P

Factory set connections, must not be modifi ed
1 Voltage supply of control 24 V DC
2 Encoder connection
3 Reed contact connection (end position sensor)
4 Motor connection
ENGLISH