Priority Scan Channel - Uniden UH047sx Operating Manual

PRIORITY SCAN CHANNEL

To set a priority scan channel:
1. Press select/ momentarily four times while in
standby mode to enter Priority Scan Channel
mode. The current priority channel will be
indicated.
2. Press or key to increase or decrease the
desired channel number.
3. Press select/ three times to confirm and exit
to standby mode. PRI will be displayed when a
priority channel has been selected.
BCL (Busy Channel Lockout) ON/OFF
BCL is used when CTCSS or DCS is selected to prevent transmission when
the uh047sx detects a transmission from another unit using the same CTCSS
or DCS code.
To set BCL ON/OFF:
1. Press select/ momentarily five times while in
standby mode to enter BCL ON/OFF mode.
The current BCL status will be indicated.
2. Press or key to select ON (on) or OFF (oF).
3. Press select/ two times to confirm and exit to
standby mode. BCL will be displayed when BCL on
has been selected.
SCAN CHANNEL MEMORY
To store a channel into Scan Channel Memory:
1. Select desired channel using ch/hi/lo key and
2. Press and hold mem/SCN key. MEM will appear on the display.
Repeat steps 1 and 2 to clear channel from Scan Channel Memory.
or
(11)
key.