Programming Scan Channels; Priority Channel; Choosing A Priority Channel; Drop-Out Delay - Uniden UH075 Operating Manual

UT01913ZZ_1 11/21/03

Programming Scan Channels

1. Select which Scanning Mode you wish to use OS or GS Mode.
OS is indicated by the absence of the GS icon.
2. Select the channel you want to store by pressing
3. Press and hold
short tone beeps are heard.
4. To remove the channels from Memory, press and hold
once more. Two short tone beeps are heard and the MEM icon disappears.

PRIORITY CHANNEL

The Priority Channel feature allows user to monitor one of 40 channels in the
UH075, monitoring it every 1.5 secs. during Group Scanning.

Choosing a Priority Channel

The starting channel, when Group Scanning is initiated, is always the Priority
Channel. To change the priority channel setting while scanning, (eg. PRI
Channel is CH17 (476.825 MHz ))
a. press
pauses).
or
b. press

DROP-OUT DELAY

While scanning, the UH075 stops at a busy channel and receives a
transmission. When the received signal is over, the unit will wait for 3 seconds
for the return of the signal, otherwise, the radio resumes scanning.
5:50 PM
mem
for 1.5 secs. to store. MEM icon appears and two
, to select a higher channel (scanning
, to select a lower channel.
15
Page 15
or
mem
.
for 1.5 secs.