ECCB OUTDOOR Adirondack Assembly Instructions

Rockers

Adirondack Rocker

(This style is used for instructions)

Important

Please Read All Instructions Carefully Before Assembling This Product

• Inspect all parts to make sure that nothing is broken or missing. If something is broken

or missing, please contact our service department at support@eccboutdoor.com.

• The rocker must be completely assembled before attempting to use it. Failure to do so

could result in damage to the chair or the user.

• Use proper safety gear and follow appropriate safety precautions when assembling this product.

• Important - Do not overtighten the screws.

• Only hand tools should be used for assembly. Do not use power tools.

• ECCB Outdoor will not be liable for any injury or damage resulting

from improper assembly and/or use of this product.

• Failure to follow all instructions will result in the product warranty being voided.

ECCB

O U T D O O R

Congratulations on the purchase of your new poly

lumber rocker. These easy step-by-step instructions can

be used for assembling any of the following rockers.

966 Perry Highway, Mercer, PA 16137 • Phone (800) 687-5086

ECCBOutdoor.com

Assembly Instructions

Rockers

Harbor Rocker

Lake Shore Rocker

Table of Contents

Need help?

Do you have a question about the Adirondack and is the answer not in the manual?

Page 1 • Important - Do not overtighten the screws. • Only hand tools should be used for assembly. Do not use power tools. • ECCB Outdoor will not be liable for any injury or damage resulting from improper assembly and/or use of this product.
Page 2 Parts Make sure you have received everything. If anything is missing or damaged, please contact our service department at support@eccboutdoor.com. Back - 1 pc Seat - 1 pc Arms - 2 pcs 1 Right 1 Left Top view of arms Side view of arms Rocker Bottoms - 2 pcs Brace - 1 pc...
Page 3 Let’s Get Started! Step 1 - Attach the Seat to the Arms • Line up the top holes in the arms (C) to the holes on the side of the seat (B) • Attach the arms (C) to the seat (B) using the hardware shown below * You will first have to remove the hardware from those holes Lay the seat on its side when attaching the arms...
Page 4 Step 3 - Attach the Rocker Bottoms • Position the rocker bottoms (D) to the outside of the arms (C). Make sure the short end of the rocker bottoms are facing front • Attach the rocker bottoms using the hardware shown below * You will first have to remove the hardware from those holes Step 4 - Attach the Bottom Brace •...

HarborLake shoreAdirondack rockerHarbor rockerLake shore rocker