Advertisement
Quick Links
Advertisement
Related Manuals for Verkada CM41
Summary of Contents for Verkada CM41
- Page 1 CM41 Setup Guide...
-
Page 2: Table Of Contents
In the box What you’ll need Connect Contents Mount Secure Support... -
Page 3: In The Box
Mount plate In the box 3 screws 3 wall anchors Length (including head) 52.5 mm, CM41 Camera Width 4 mm, Head width 8.3 mm 2 machine screws 2 washers 2 wing nuts Length (including head) 27.6 mm, Width 4 mm, Head width 7 mm... -
Page 4: What You'll Need
• A working internet connection • 802.3af Power over Ethernet (PoE) switch, or a PoE injector • A smartphone or laptop What you’ll need • A Phillips screwdriver or power drill with a Phillips driver bit • 1/4-inch (6.5mm) drill bit for wall anchors •... -
Page 5: Connect
Connect Grasp the plastic mount plate strap and pull Connect the camera to an 802.3af Power Go to www.verkada.com/start the cover off of the camera. over Ethernet port on your network. An orange LED on the camera’s ethernet port will indicate that it is powered and booting up. -
Page 6: Mount
Mount On the bottom of the camera, rotate the Firmly pull and seperate the mount plate mount plate clock-wise until it stops and from the camera base. Remove and is lined up with its corresponding blue discard the plastic mount plate strap. colored notch on the camera base. - Page 7 1/8 inch When placing the mount plate, take care to If your cable is routed through a hole in Use the mount plate to mark holes for For a solid material like wood or metal, drill orient it such that your camera’s target is the mounting surface, position one of the mounting screws.
- Page 8 1/4 inch 3/16 inch For drywall, drill 1/4-inch holes. Insert For a drop ceiling, drill 3/16-inch holes Plug in the camera. Line up the blue With the camera on the mount plate, rotate plastic anchors into holes and drive through the ceiling tile and insert ma- notches on the mount plate and the the entire camera body on the mount plate mounting screws into anchors.
-
Page 9: Secure
Status LED Solid orange Camera is on and booting up Secure Flashing orange Camera is updating firmware Flashing blue Camera is recording, but cannot reach the server Route the cable snuggly between the camera base and the mount plate. Place Solid blue the cover on the camera. -
Page 10: Support
Thank you for purchasing a Verkada camera. Support If for any reason things don’t work right or you need assistance, please contact us immediately. Sincerely - The Verkada Team... - Page 11 www.verkada.com/support...