Table of Contents
Advertisement
Preface
Section 1 - Preface
Before you begin
Thank you for your interest in Radiodetection's RD1100 Ground Penetrating Radar system.
Please read this user manual in its entirety before attempting to use the RD1100.
Radiodetection products, including this manual, are under continuous development. The
information contained within is accurate at time of publication; however the RD1100, this
manual and all its contents are subject to change.
Radiodetection reserves the right to modify the product without notice and some product
changes may have taken place after this user manual was published.
Contact your local Radiodetection dealer or visit
www.radiodetection.com
for the latest
information about the RD1100, including this manual, and the rest of the Radiodetection range
of products designed for locating buried utilities.
1.1 Important notices
General
This instrument, or family of instruments, will not be permanently damaged by reasonable
electrostatic discharge and has been tested in accordance with IEC 801-2. However, in extreme
cases temporary malfunction may occur. If this happens, switch off, wait and switch on again. If
the instrument still malfunctions, disconnect the power supply for a few seconds before
restarting.
Safety
WARNING! Failure to comply with safety warnings can cause serious injury or death
CAUTION!: Failure to comply with safety cautions can result in damage to equipment or
property
This equipment shall be used only by qualified and trained personnel, and only after fully
reading this Operation Manual.
Use the Display Unit only as specified in these operating instructions or the protection provided
by the unit may be impaired.
The battery charger/AC adapter must only be connected to a power outlet which provides a
protective earth (ground).
Connect the AC power cord only to designated power sources as marked on the battery
charger/AC adapter.
RD1100 Operation Manual
1
© Radiodetection 2016
Advertisement
Table of Contents
