Table of Contents
Advertisement
If the data was collected with a shallower depth, the depth setting can still be increased after
the fact, when reviewing the data. In general, it is recommended that you set your displayed
depth to 1.5 - 2 times the depth you expect the deepest target to be.
Position – Pressing + and - under the Position button allows you to change the length
of data display on a single screen. This is also known as horizontal scaling. The pre-set
values range from 10m to 30m (25' to 100'), see Figure 8-7.
One reason for setting this to 30m would be to fit more data on the screen and look for
consistency among hyperbolas that were crossed.
Figure 8-6: Varying displayed depth
© Radiodetection 2016
35
RD1100 Operation Manual
Data Collection
Advertisement
Table of Contents
