Table of Contents
Advertisement
Tools & Setup
From here you can select the following:
Language
Pressing Language will cycle between available languages.
Units
Pressing Units will cycle between US Standard and Metric Units.
Volume
Scroll bar for adjusting the volume of clicks and beeps heard during operation. This can also be
changed by using the Swipe Down menu (Section 5.4) anytime the system is not collecting
data.
Brightness
Scroll bar for adjusting the brightness of the screen. This can also be changed by using the
Swipe Down menu (Section 3.4) anytime the system is not collecting data.
NOTE: Increasing the screen brightness also increases power consumption, thus reducing
battery life.
Screen saver
Pressing the Volume/Brightness button at the bottom of the screen will change the bottom menu
options, allowing you to change the volume and brightness as well as turn the Screen Saver on
and off. You can set the time interval to either 1 minute or 5 minutes before the screen turns off.
Once the screen turns off, simply touch anywhere on the screen to turn it back on again.
Auto-Hide Buttons
If this is set to ON, then in Line Scan mode, the buttons at the bottom of the screen disappear
shortly after data collection begins, effectively enlarging the area for data display. The buttons
will re-appear after a couple of seconds whenever the sensor stops moving forward, is in back-
up mode or any button is pressed on the keypad.
Anonymous Usage Statistics
When this is set to ON and the user is connected to a wireless network, any system
malfunctions will trigger an automatic notification to the manufacturer. This is to help with
gathering information about any system irregularities. As the name suggests, the notification is
completely anonymous and no personal information is sent.
6.2 System Settings
Press System Settings to enter the menu shown in Figure 6-3.
RD1100 Operation Manual
16
© Radiodetection 2016
Advertisement
Table of Contents
