Closing The Housing; Setting Up An External Strobe; About Fiber Optic Cords - Ikelite 6170.70 Instruction Manual

Underwater housing for panasonic lumix dczs70, zs80, tz90, tz95
Table of Contents

Advertisement

Closing the Housing

1. Make sure the o-ring is clean and in its proper location on the back
of the housing. The rear housing o-ring does not require lubricant
to make a seal.
2. Place the back onto the housing front.
3. Make sure nothing is interfering with the o-ring or the back of the
housing.
4. Place each lid snap into the corresponding hook on the housing
back.
5. Push the lid snaps towards the housing until they are flat against
the housing and the lock has engaged. Close both lid snaps at the
same time.
6. Check the o-ring seal. The o-ring should form a uniform, solid line
visible through the back of the housing.
7. Check control functions.

Setting Up An External Strobe

We recommend attaching an external strobe for the optimal color and
clarity in a wide variety of photographic situations, including daylight
photography.
This housing provides fiber optic ports for optical triggering of up to
two strobes.

About Fiber Optic Cords

Connecting a strobe via fiber optic cord requires the camera's built-in
flash to fire for every photo. Rapid firing will be limited to the recycle
time of the camera's built-in flash or the recycle time of the strobe,
whichever is slower.
The following fiber optic cords are compatible with this housing:
13

Advertisement

Table of Contents
loading

Table of Contents