Resetting The Scanner - Uniden UBC92XLT Owner's Manual

UB324 Paper OM reduced size.fm Page 43 Wednesday, February 2, 2005 8:01 PM

Resetting the Scanner

If the scanner's display locks up or stops operating
properly, you might need to reset the scanner.
Caution: This procedure clears all the information
(except the band plan data) you have stored in the
scanner. Before you reset the scanner, try turning it
off and on to see if it begins working properly. Reset
the scanner only when you are sure it is not working
properly.
1. Turn off the scanner.
2. While holding down 2, 9, and Hold, turn on the
scanner. It takes about 3 seconds to initialize
and CLEAr appears.
Troubleshooting
43