Resetting The Scanner - Uniden UBC30XLT Owner's Manual

UB333 Paper OM reduced size.fm Page 33 Friday, June 3, 2005 1:43 PM
Scan The channel
won't stop might not be
(continued) active.
Scan You must
won't press RSM/
start. HOLD to scan.
The squelch
might need to
be adjusted.
One or more
channels might
be locked out.
The antenna
might need to
be adjusted.

Resetting the Scanner

If the scanner's display locks up or stops operating
properly, you might need to reset the scanner.
Caution: This procedure clears all the information
(except the band plan data) you have stored in the
scanner. Before you reset the scanner, try turning it
off and on to see if it begins working properly. Reset
the scanner only when you are sure it is not working
properly.
1. Turn off the scanner.
2. While holding down
scanner. It takes about 3 seconds to initialize
and CLEAr appears.
Wait for a
transmission on the
channel.
Press RSM/HOLD.
Adjust the squelch
threshold. See
"Turning On The
Scanner and
Setting Squelch" on
Page 25.
Make sure the
channels you want
to scan are not
locked out.
Check the antenna
connection.
and , turn on the
Troubleshooting
33