The Timer Function - Black & Decker BXAC65002GB Instruction Manual

Table of Contents

Advertisement

Using the Ice Packs
This unit comes complete with 2 x ice packs, for
added cooling functionality.
To make use of the included ice packs, start by
filling them with water. To do this, rotate the lid
counter-clockwise to loosen it. Fill the pack with
water, then replace the lid and turn it clockwise to
tighten it.
Note! Be careful not to overfill the bottle, as water
expands when frozen. If necessary, leave the lid
loosely tightened after filling.
Once one or both ice packs have been filled, put
them in the freezer and leave them to chill for a
few hours or overnight.
When the ice packs have frozen through, take
them out of the freezer and insert them into the
previously filled water tank. This will help chill the
water in the tank, for more effective cooling.
Swing
This fan is equipped with an swing function in its
inner louvers.
Press the Swing button to turn the swing
function on and off. The fan's inner louvers will
automatically begin to swing from side to side. The
corresponding indicator will light up on the unit's
control panel to show the swing function has been
turned on.
Press this button again while the unit is swinging
to turn this function off. The louvers will stop
swinging and become locked at their latest angle,
and the corresponding indicator will go out on the
unit's control panel to show the swing function has
been turned on.
Note! The inner louvers cannot be manually
adjusted. To change the cooling angle of the inner
louvers, turn the swing function on, as described
above, wait until the louvers are at the required
cooling angle, then turn the function off.
(Original instructions)
Controlling the Air Flow
This unit allows for manual control of the air flow
through the positioning of the outer louvers at the
front of the unit.
To position the louvers, gently hold them by the
lip and push them upwards or downwards as
required. Push the louvers upwards to open them,
or downwards to close them.

The Timer Function

The unit is complete with a built-in digital timer,
allowing for pre-set cooling cycles of up to 8
hours.
Press the 'Timer' button on the remote control
or the unit's control panel to activate the timer
function. The text '1H' will show on the unit's LCD
display to indicate the timer function has been
activated.
Once the timer function is activated, repeatedly
press the 'Timer' button on the remote control or
the unit's control panel to increase the length of
the pre-set time by increments of 1 hour, from 1 up
to 8 hours. The corresponding number will show
on the unit's LCD screen to indicate each timer
has been selected.
Note! The timer function operates in ascending
order only. To decrease the length of the cooling
cycle, repeatedly press the 'Timer' button on the
remote control or the unit's control panel until a full
cycle has been completed and no text is showing on
the unit's LCD screen; then, repeatedly press this
button again until the corresponding length of time
has been selected. For example, to go down from a
5 hour cooling cycle to a 2 hour cooling cycle, press
the 'Timer' button until the timer has gone past the
'8h' setting and the LCD screen is blank, then press
it twice more until the text '2h' appears on the unit's
LCD screen.
ENGLISH
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents