Speed Selection; Mode Selection; The Cooling Function; Emptying The Water Tank - Black & Decker BXAC65002GB Instruction Manual

ENGLISH (Original instructions)

Speed Selection

♦
There is a choice of 3 airflow settings: Low (1),
Medium (2) or High (3).
♦
Press the speed selection button on the remote
control or the unit's control panel to cycle through
the available airflow settings. The corresponding
indicator will light up to show each speed has
been selected.

Mode Selection

There is a choice of 3 cooling modes: Normal,
Natural and Sleep.
♦
In Normal mode, the unit will cool continuously at
the desired speed.
♦
In Natural mode, the unit will automatically cycle
through different airflow settings to simulate a
natural breeze.
♦
In Sleep mode, the unit will automatically cycle
through different airflow settings to simulate a
gentle natural breeze suitable for night-time use.

The Cooling Function

♦
This unit is equipped with a cooling function, ideal
for lowering room temperature or refreshing the air
inside a room.
♦
Press the 'Cool' button on the remote control or
the unit's control panel to activate the cooling
function. The corresponding indicator will light up
to show the cooling function has been activated.
♦
Press this button again while the cooling function
is in operation to turn this function off. The
corresponding indicator will go out to show the
function has been turned off.
Note! Always ensure the water tank is filled before
attempting to use the cooling function; otherwise,
this function will not operate correctly. Refer to the
'Filling the Water Tank' section below for instructions
on how to fill the water tank.
8
Filling the Water Tank
♦
To remove the water tank to conveniently fill under
a tap, turn the safety locking mechanism at the
underside of the unit to a horizontal position to
release the tank from the unit. Once the lock has
been released, release the clip connecting the
water tank to the unit's inner wiring, located at the
far end of the water tank. To release this clip, grip
it firmly and push both tabs inward at the same
time to loosen the clasp, then pull it firmly away
from the water tank until it detaches completely.
Once the clip is detached, place the water tank
under a running tap or shower and fill it up as
required.
♦
Alternatively, pull the water tank partway out of
the unit and fill it up with a hose, bucket or shower
head, as required.
♦
Once the water tank is full, place it back into the
unit, ensuring the connecting clip slots into place.
To do this, align the two tabs on either side of the
clip with the corresponding notches on the main
body of the water tank, then push the clip down
until they click into place. Once the clip is in place,
push the water tank back into the unit and turn the
locking mechanism to a vertical position to secure
it into place.

Emptying the Water Tank

♦
To empty the water tank, follow the steps detailed
above to detach it from the main body of the unit.
Once the water tank has been detached from the
main body of the unit, tip it over and empty it into a
sink or drain.
♦
Once the water tank is empty, place it back into
the unit, ensuring the connecting clip slots into
place. To do this, align the two tabs on either side
of the clip with the corresponding notches on the
main body of the water tank, then push the clip
down until they click into place. Once the clip is in
place, push the water tank back into the unit and
turn the locking mechanism to a vertical position
to secure it into place.
Note! If not using the dehumidifying function again,
ensure the water tank is fully dry before placing it
back into the unit.