Din-E Installation - Uniden PRO630XL Owner's Manual

UNIDEN Model PRO630XL

DIN-E Installation

Mounting Using the DIN-E Sleeve
If you are unsure about how to install your PRO630XL in your vehicle using the DIN-E sleeve,
consult your automobile manufacturer, dealer, or a qualified installer. Before installing, confirm
that your PRO630XL fits in the desired mounting area and you have all the necessary materials
to complete the task. Your PRO630XL requires a 53 x 183 x 135 mm mounting area. Allow an
additional 60 mm space behind the unit for connectors and wires.
1. Remove the bracket if previously attached.
2. Install the DIN-E sleeve into the opening in your dashboard, lip facing out.
3. Push out the top and bottom tabs to hold the sleeve firmly in place.
4. Remove the flat rubber ring fitted around the cabinet sides near the front of the PRO630XL.
Fit the supplied DIN-E rubber ring in it's place. When fitted the rubber ring will act as a
seal against the DIN-E sleeve. At the left and right sides of the ring there will be a slot space.
The slots in the fitted DIN-E Rubber Ring will enable proper removal of radio from the
DIN-E sleeve.
5. Before inserting the PRO630XL in the sleeve, attach the cable from the previously mounted
antenna. Attach the DC Power leads. RED goes to a positive (+) connection on your fuse
block while BLACK connects to the vehicles chassis ground (-). Be sure all the connections
are routed away from any potentially pinching or slicing sheet metal.
6. Slowly slide the PRO630XL into the sleeve until it locks in place.
If you plan to use the Rear MIC Jack or connect an external speaker at a later time,
expect to remove the unit for ease of making those connections.
11