Table of Contents
Advertisement
Chapter 3
Installing the VP-II Controller
Install the Controller on the inner wall, near enough to the VP-II
Scanner that it can be reached with the cables provided. The
Controller cable length should not exceed 4m. Select a place where
access for maintenance is convenient. Ensure that a power outlet is
near.
Make a hole in the wall for affixing the controller; then insert a screw
approximately two thirds of the way in. Fix the controller on the wall
by hooking it on the screw.
Screw type : 3Φ× × × × 20mm
Connect the power cable and the controller cable. Ensure that the
connection cable is not exposed to the outside.
Door Lock
DIP S/W
VP-II Scanner
SMPS
7
Advertisement
Table of Contents
