Preface: Read This Section Before Starting - Techsphere VP-II M Installation Manual

Preface: Read this section before starting.

Thank for your choosing the Techsphere VP-II M Hand Vascular
Pattern Recognition system. This installation guide describes how to
install the components of the VP-II M system, the basic model of
Techsphere's VP-II Hand Vascular Pattern Recognition system.
It is recommended that installation be performed by a trained
technician. Please contact your local Techsphere sales representative
for an installation visit. Only a Techsphere technical specialist or
local sales representative should open components of VP-II systems
in order to perform repairs or to expand the system.
Installation must be performed according to the instructions in this
installation guide. If the VP-II M system is installed improperly, the
system may not function properly. Symptoms of improper
installation range from complete operation failure to lowered system
performance.
In order to connect a VP-II M system to a host PC, a VP-II Converter
is required. A VP-II Data Repeater is required to extend effective
cable length for any system in which components of the VP-II
system are separated by more than 100 meters.
It is strongly recommended that you read the entirety of this guide
before installing the VP-II M Hand Vascular Pattern Recognition
system. For your own safety and for the long life of the system,
handle the system carefully, according to the procedures and
suggestions in this manual.
Don't hesitate to contact your local Techsphere sales representative
or Techsphere customer support (customerservice@tech-sphere.com)
if you determine that you need service, support, information, or
replacement equipment.
i