Table of Contents
Advertisement
11 - 2 Stopping Operation
Stop rotation
Stop supplying the
coolant or oil mist
12.
INSTALLATION OF THE BRUSHLESS MOTOR SPINDLE
WARNING
When installing a Brushless Motor Spindle to a fixed base, make sure the fixed base is grounded in
order to avoid the risk of an electric shock.
CAUTION
・ When installing a Brushless Motor Spindle, do not hit, drop or cause shock to the Brushless Motor
Spindle. This may cause damage to internal components and result in malfunctions.
・ When mounting the Brushless Motor Spindle, be sure to secure within Clamping Area etched on the
Brushless Motor Spindle O.D. If the Brushless Motor Spindle is installed incorrectly, damage to the
internal components is possible.
・ Cautions when tightening the securing bolts on to a Split Type Holder
Do not over-tighten the bolt. This will cause damage to Brushless Motor Spindle's precision.
Tighten the bolt until the Brushless Motor Spindle body can not be rotated by hand within the
fixture.
Extreme tightening is not necessary or recommended.
Apply working force and check that the Brushless Motor Spindle is tight before using.
(1) When mounting a Brushless Motor Spindle, refer to the Clamping Area etched on the Brushless Motor Spindle
(Fig. 22).
* When installing the Brushless Motor Spindle, it is recommended to use a " Grip Ring GR - 40 (sold
separately (Fig. 23)) ". If the Grip Ring GR - 40 cannot be used due to the restriction of dimension and
space, install as shown in (2) below.
34
Stop rotation of the Brushless Motor Spindle.
Stop supplying the coolant or oil mist into the Brushless Motor Spindle.
* When stopping the coolant air, after stopping supplying the coolant or oil mist, be sure to supply
the coolant air for a least 5 minutes.
40
90
(Clamping Area)
CLAMPING AREA
Fig. 21
Fig. 22
Grip Ring GR - 40 (sold separately)
CLAMPING AREA
Fig. 23
Advertisement
Table of Contents
