Connection Of The Coolant Hose Or The Oil Mist Hose - Nakanishi BMS-4020-MQL Series Operation Manual

（4）Insert the Air Hose of the Motor Cord side into the Dry Air Cooling Supply Port (φ6) on the rear of the
Brushless Motor Spindle.
* The coolant Air Hose is attached to the Brushless Motor Spindle.
(Attached to the Brushless Motor Spindle)
（5）Insert the Drain Hose (Air Hose (φ6)) into the Drain Outlet Port on the rear of the Brushless Motor Spindle.
10.

CONNECTION OF THE COOLANT HOSE OR THE OIL MIST HOSE

CAUTION
The Insert and Ferrule Set are single use only.
Replace the Insert and Ferrule Set with new ones after removing the Coolant Hose or Oil Mist Hose
from the Brushless Motor Spindle. The Insert and Ferrule Set are replacable by the end-user (Refer to
P26 Table. 2).
10 - 1 Connection of the Oil Mist Hose (air pressure hose)
（1）Press the insert (Accessories) into the Oil Mist Hose
(φ6 : not included / prepared by the end-user) (Fig. 15).
（2）Insert the Oil Mist Hose of (1) into the Oil Supply Port (φ6) on the rear of the Brushless Motor Spindle (Fig.16).
Insert
Insert
Air Hose
Drain Hose (Air Hose (φ6))
Insert
Insert (Accessories)
Insert
Insert
Air Hose
(Attached to Motor Power Line)
Fig. 13
Fig. 14
Oil Mist Hoseφ6
Fig. 15
Oil Supply Portφ6
Insert (Accessories)
Oil Mist Hoseφ6
Fig. 16
Cooling Air Supply Portφ6
Drain Outlet Portφ6
31