Table of Contents
Advertisement
CAUTION
⑩ Stop working immediately when abnormal rotation or unusual vibration are observed. Immediately,
please check the content of section " 15. TROUBLESHOOTING ".
⑪ Always check the tool, collet, collet nut, drain hose, coolant hose or oil mist hose and cooling air
supply hose for damage before and after operating.
⑫ If the collet or collet nut show signs of wear or damage, replace them before a malfunction or
additional damage occurs.
⑬ After installation, repair, initial operation, or long periods of non operation, please refer to section
" 13 BREAK-IN PROCEDURE " detailed in Table. 3. When checking the Brushless Motor Spindle,
no vibration or unusual sound should be observed during rotation.
⑭ Do not disassemble, modify or attempt to repair this Brushless Motor Spindle. Additional damage
will occur to the internal components. Service must be performed by NSK NAKANISHI or an
authorized service center.
⑮ When using this Brushless Motor Spindle for mass production, please consider the purchase of an
additional Brushless Motor Spindle to be used as a back-up in case of emergency.
⑯ Securely connect each of the hoses (Coolant souce connection, air hose, drain hose, coolant
hose, or oil mist hose) to avoid accidental disconnection during use.
2.
BASIC PACKAGE
When opening the package, check if it includes all items listed in " Table. 1 Packing List Contents ".
In the event of any shortage, please contact either NAKANISHI (see the " 4. CONTACT US " section) or your local
dealer.
Table. 1 Packing List Contents
Common
Brushless Motor Spindle・・1pc.
Inspection Card・・1pc.
BMS - 4020 - MQL / BMS - 4040 - MQL
Collet Nut (CHN - 16)・・1pc.*
BMS-4020-MQL-CHK / BMS-4040-MQL-CHK
Collet Nut (K-265)・・1pc.*
検査成績表
Inspection Card
* The Collet Nut and Ferrule Set are to be attached to the Brushless Motor Spindle.
Insert・・1pc.
Operation Manual・・1set
取扱説明書
OPERATION MANUAL
Wrench (17 x 22)・・2pcs.
Wrench （12 × 14） ・・2pcs.
Ferrule Set・・1set *
23
Advertisement
Table of Contents
