Replace Electronics Cover - Graco e-Xtreme Z60 Instructions Manual

Repair

Replace Electronics Cover

Removal
1. Follow the Pressure Relief Procedure on page 9.
2. Disconnect unit from power source.
3. Remove the lower from the sprayer (see the
Sprayer manual). NOTE: This is required to
complete the calibration procedure (page 18).
4. Follow Disconnect Fan Wires on page 14.
5. Remove lower ground screw and power cord
ground wire, then remove the box sleeve mounting
screw (126) and box sleeve (88).
F . 16: Junction Box Sleeve
IG
6. Remove 12 screws (24) and washers (43) from
electronics cover (3).
F . 17: Electronics Cover Removal
IG
16
88
126
43
3
43
7. Carefully separate the electronics cover (3) from the
driver, then disconnect the wires.
F . 18: Remove Electronics Cover
IG
All wires must be disconnected before the cover is
completely removed. Hold the cover in place while
disconnecting wires or let the cover rest on a work
surface to avoid damaging the wires and connections.
8. Pull wire connectors down, out of the harness clip
and disconnect the motor power and motor
temperature wires (M).
F . 19: Motor Wires
IG
9. Disconnect the stroke position sensor wire (29).
20
29
F . 20: Stroke Position Wire
IG
3
NOTICE
M
3A6919A