Table of Contents
Advertisement
Replace the Rechargeable Handset Battery Pack
)
Remove the four screws
holding the battery
compartment with a
screwdriver and take off
the battery cover. Remove
the old battery pack from
the battery compartment.
)
Line up the red and black
wires with the polarity label
in the battery compartment
(the connector only fits one
way). Push the connector
in firmly; you should hear
the connector click into
place.
3)
Tug on the battery wires
slightly to make sure you
have a good connection.
4)
Before placing the battery
cover back on the handset,
check the rubber seal
located on the under side
of the cover: make sure
that the seal is in good
condition and that there
is no foreign matter under
the seal.
Note: If the rubber seal
appears warn, nicked, or dried
out, replacement seals are
available through the Uniden
Parts Department. See the
back cover page for contact
information.
7
Advertisement
Table of Contents
