Install The Rechargeable Battery Pack Into The Handset - Uniden XS 1410 Owner's Manual

B. Install the rechargeable battery pack into the handset
The handset is powered by a rechargeable battery pack.
The battery recharges automatically when the handset is
placed in the base unit.
NOTE: If your home has specially wired alarm
equipment connected to the telephone line, be
sure that installing the system does not disable
your alarm equipment. If you have questions
about what will disable your alarm equipment,
contact your telephone company or a qualified
installer.
1) Press down on the handset battery case cover (use the
finger indention for a better grip) and slide the cover
downward to remove.
2) Plug the battery pack connector (red & black wires) into
the jack inside the battery compartment (the connector
notches fit into the grooves of the jack only one way).
Match the wire colors to the polarity label in the battery
compartment, connect the battery and listen for a click to
insure connection.
Fit the battery pack into the battery compartment.
3) Before replacing the battery cover, pull on the battery
wires slightly. If the connection is secure, the jack will
stay in place. Then place the battery case cover back on
the handset by sliding it upwards until it clicks into place.
NOTE: For optimum performance, use only the
Uniden Battery (BT-905s) supplied with your
phone.
C. Connect the base unit and charge the handset
1) Connect the AC adapter to the DC IN 9V
jack and a standard 240V AC wall outlet.
2) Set the base unit on a desk or tabletop, and
place the handset in the base unit with the
keypad facing forward.
3) Make sure the in use/ LED illuminates. If
the LED does not illuminate, check to see
that the AC adapter is plugged in and the
handset makes good contact with the base
charging contacts.
NOTICE: Do not place the power cord
where it creates a trip hazard or where
it could become chafed and create a
fire or electrical hazard.
NOTE:
• Use only the supplied PS-S092YL3
• Connect the AC adapter to a
• Place the base unit close to the
4) Charge your handset at least 15-20 hours
before plugging the phone line.
5) Once the handset battery pack is fully
charged, connect the telephone cord to the
TEL LINE jack and a telephone outlet. If
your telephone outlet isn't modular, contact
your telephone company for assistance.
1410 OM.indd 3
AC adapter. Do not use any other
AC adapter.
continuous power supply.
AC outlet to avoid long extension
cords.
Route the cord. Route the cord.
3
Route the cord. Route the cord.
3/6/08 2:01:30 PM