Replace The Rechargeable Handset Battery Pack - Uniden TWX977 Owner's Manual

Replace the rechargeable handset battery pack

1. Remove the 4 screws holding the
battery compartment with a
screwdriver and take off the battery
cover. Remove the old battery pack
in the battery compartment.
2. Plug the replacement battery
connector (red & black wires) into the
small, black jack inside the battery
compartment. (The connector
notches fit into the grooves of the
jack only one-way.) Match the wire
colors to the polarity label in the
battery compartment, connect the
battery and listen for a click to insure
connection.
3. Make certain you have made a good
connection by slightly pulling on the
battery wires. If the battery connector
is not securely connected, the
handset will not charge properly.
4. Before placing the battery cover back
on the handset, make sure there is
no foreign matter under the rubber
seal located on the under side. By
inserting the bottom first, place the
battery cover back on the handset
and tighten the 4 screws.
If the rubber seal appears warn,
nicked, or dried out, replacement
seals are available through the
Uniden Parts Department. If you
have questions regarding the
installation of the battery pack and/or
rubber seal, please call our
Customer Service Hotline at 1-800-
297-1023.
7
Rubber Seal