Con@ctivity via a direct WiFi
connection (Con@ctivity 3.0)
Prerequisite: WiFi-enabled Miele
cooker hood
If you do not have a home network, you
can establish a direct connection
between the hob and the cooker hood.
Switch the cooker hood off.
Press and hold the (B*) control.
Press the (1*) control at the same
time.
* Cooker hoods with sensor controls.
2 will light up constantly, and 3 will flash
on and off.
The cooker hood is ready for
connection for the next two minutes.
Switch the hob on.
Place an induction-compatible pan
on the hob.
Touch and hold the 0 and 7 sensor
controls on the numerical display at
the same time for 6 seconds.
The seconds can be seen counting
down in the timer display. After the time
has elapsed, a progress light appears
during the connection attempt. If the
connection was successful, the
code : appears in the timer display.
If the connection could not be
established, the timer display will show
the code :. Repeat the steps above.
When successfully connected, 2 and
3 will light up constantly on the cooker
hood.
Before using for the first time
Quit connection mode on the cooker
hood by pressing the run-on
control .
Con@ctivity is now activated.
With a direct WiFi connection, it is not
possible to connect the hob and the
cooker hood to a home network. If this
is desired later, the direct WiFi
connection between the hob and the
cooker hood must first be reset (see
"Initial commissioning – Con@ctivity"
and "Disconnecting the WiFi" in the
operating and installation instructions
for the cooker hood).
21