Page 1
WE-EF LEUCHTEN Installation and Maintenance Instructions Pole Mounted Luminaire ZFT400 Do not open during installation This product is factory-sealed. Refer to the instructions contained in this document for details. Surge Protection This product features built-in surge protection circuitry in compliance with applicable standards.
Page 2
Pole Mounted Luminaire ZFT430-FT ZFT460-FT ø 170 ø 250 ZFT434 ZFT464 ø 76 x 80 ø 76 x 80 ZFT440-FT ZFT470-FT ø 170 ø 250 ZFT444 ZFT474 ø 76 x 80 ø 76 x 80 IP66. IK10. Class I. ta = 25°C Weight for ZFT430-FT/434 for ZFT440-FT/444...
Light Source Maintenance Apart from cleaning the product’s exterior surfaces, no special maintenance work is required. Do not use high-pressure cleaners. In case of component failure due to abnormal circumstances or at end of life, replacement must be carried out Warning: Do not open luminaire while mains supply is switched on.
Installation The product must be installed and maintained by a building/construction and/or electrical regulations and relevant legislation. Warning: Switch off mains electrical supply prior to installing and connecting the luminaire. Notice: than the original manufacturer, then the warranty will no longer be valid and shall become the full respon- sibility of the modifying person/organisation.
Installation Procedure 1) Switch off mains electrical supply. 2) Check that rating shown on luminaire label conforms with mains electrical supply. 09/19 IP66 ZFT444 220-240V/50 Hz, 1-10 115-XXXX SOE XXXXXXX LED 4000K 18W item no. XXX (example) 3) Feed mains cable A into column B, while 4) Trim mains cable A to the desired length and setting luminaire in position by following the connect the leads to their respective terminals...