Installation Procedure
1) Switch off mains electrical supply.
3) Feed mains cable A into column B, while
setting luminaire in position by following the
orientation indicator C. Tighten set screws D.
2) Check that rating shown on luminaire label
conforms with mains electrical supply.
ZFT444
115-XXXX
LED 4000K 18W item no. XXX
(example)
4) Trim mains cable A to the desired length and
connect the leads to their respective terminals
at the base of the pole (L = Phase, N = Neutral,
= Earthing)
Supply cable
4
09/19 IP66
220-240V/50 Hz, 1-10
SOE XXXXXXX