Chord Hugo TT 2 Quick Start Manual
Hide thumbs Also See for Hugo TT 2:

Advertisement

Quick Links

Chord Electronics
Hugo TT 2 | Quickstart Manual
Quickstart Manual

Introduction

Welcome to the Hugo TT 2 Quickstart Guide. This shortened guide is
supplementary to the main manual which should be referred to for full
safety and operational information.
Please note, more information on any of these topics is listed within the
full manual found under the product page:
chordelectronics.co.uk/product/hugott2

Warranty

The Hugo TT 2 comes with a comprehensive 3-year warranty. To
activate this warranty, please register your device via the Chord
Electronics website:
chordelectronics.co.uk/register-product
Note: please do not use a third-party charger with the Hugo TT 2 as it
voids any warranty

Connecting your source to Hugo TT 2

In order to use the Hugo TT 2, you must connect your source to any
input of the device. You can connect multiple sources if you wish and
select between them later from within the menu.
Please note that if you are using the USB input with a MAC/Linux
device you will not need a driver but if you are connecting a Windows
device it will need a driver from the Hugo TT 2 section of our website:
chordelectronics.co.uk/product/hugott2
The Pumphouse, Farleigh Lane, East Farleigh, Kent, ME16 9NB, United Kingdom
info@chordelectronics.co.uk
chordelectronics.co.uk
1.0
1.1
2.0
Input
Connecting to a Hugo M Scaler from the Hugo TT 2
If using Hugo M Scaler you should use the Dual BNC cables provided
to connect it with the Hugo TT 2. By using M Scaler all of your inputs
must now be connected to M Scaler and not TT 2 - refer to the M Scaler
User Manual.
OPT OUT S/PDIF
OPT OUT
S/PDIF
DUAL BNC OUT
DUAL BNC OUT

Connecting an amplifier to Hugo TT 2

To connect an amplifier, such as TToby, to the Hugo TT 2, you should
connect the outputs of TT 2 to the inputs of your amplifier.
Output

Connecting the power to Hugo TT 2

Connect only the supplied power supply to the DC 15V input of Hugo
TT 2. Once connected to the Hugo TT 2, it may start automatically.
Please make sure none of your other devices are switched on at this
point.
3.0
4.0
5.0

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Hugo TT 2 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Chord Hugo TT 2

  • Page 1 Hugo TT 2. By using M Scaler all of your inputs must now be connected to M Scaler and not TT 2 - refer to the M Scaler safety and operational information.
  • Page 2 The gain range selection is only available in ‘AMP’ mode and you should always begin on the ‘Low’ gain mode, but if you find that Hugo TT 2 is not loud enough then you should switch the ‘High’ gain mode, always remembering to begin on the lowest volume level.

Table of Contents