MegaRAID Controller Firmware Update Procedures
This chapter provides instructions on how to flash MegaRAID controller firmware.
Please visit our website at www.supermicro.com for more information about firm-
ware/utilities downloads.
5-1
Flashing Firmware Using MegaCLI under DOS
1. You need the MegaCLI utility and ROM file (smc3108.rom) to flash the Mega-
RAID firmware.
2. Boot from the USB key and use the following command syntax as shown below,
or run the batch file.
megacli –adpfwflash –f <filename.rom> -a0
Chapter 5: MegaRAID Controller Firmware Update Procedures
Chapter 5
5-1