Husqvarna 570 XP/G Workshop Manual page 49

11. Fit the filterholder with choke on carburettor. Use
long screws (L) on the upper part and short screws
(M) on lower part. See fig. 14.
12. Fit carburettor with filter holder on manifold.
• Fit choke shaft (P) in notch.
• Slide choke rod (N) in guide (O).
• Push in the choke rod (Q).
• The impuls nipple should meet the impuls hose
(R).
• Tighten the screws
• Connect the rear rubber mount (S). See fig. 15.
13. Assemble the following parts:
• Muffler. See page 15.
• Cylinder cover. See the Operator's Manual.
• Chain and bar. See the Operator's Manual.
14. If a new piston and/or cylinder is fitted the chainsaw
should be run-in for 3-4 hours. See carburettor
settings on pages 39
PISTON..and..CYLINDER
2 Nm.
and 40.
Fig. 14
N
O
Fig. 15
Lx2
Mx2
R
Q
P
English – 49