Husqvarna 570 XP/G Workshop Manual page 17

Remove the throttle cable and lever. See fig. 19
Inspection
Clean all components and check the following:
1. That the throttle cable and lever are undamaged and
run easily.
2. That the lock activation mechanism is not worn.
See fig. 19.
Assembly
1. Lubricate all guide pins and joint surfaces using light
oil.
2. Fit the throttle cable and lever (A). Fit the throttle
lever (C) with pivot (B). See fig. 20.
3. Fit the spring in the recess in the throttle lock (D).
Hold the spring in place and locate the throttle lock
in the recess in the hand grip.
4. Fit the throttle lock pivot (B) with the help of a driver.
See fig. 20.
5. Fit the hand grip insert with a screw, when the
throttle, lever, throttle cable and throttle lock with
spring are correctly fitted. See fig. 21.
SAFETY.EQUIPMENT
Fig. 19
A
B
C
Fig. 20
Fig. 21
B
D
English – 17