Husqvarna 570 XP/G Workshop Manual page 21

Assembly
Assemble the ignition system as follows:
1. Fit the flywheel on the spindle. Turn it gently until the
key on the flywheel mates with the recess in the
shaft.
2. Fit the flywheel washer and nut. Tighten the nut to
35 Nm. See fig. 7.
3. Fit the two pawls on the flywheel. See fig. 6.
4. Remove the piston stop.
5. Fit the ignition module (B) without tightening its
bolts. See fig. 8.
6. Turn the flywheel so that its magnet (G) comes
opposite the ignition module. See fig. 8.
A
Fig. 5
Fig. 6
ELECTRICAL.SYSTEM
7. Insert the feeler gauge "Air Gap Tool" (0.3 mm)
between the ignition module and the flywheel
magnet. The clearance only applies to the two lower
pegs on the ignition module. See fig. 8.
8. Push the ignition module against the flywheel and
tighten the bolts (D) to 4 Nm. See fig. 8.
9. Fit the cable guide and press on the ignition cable.
Connect the short-circuit cable to the switch. See
fig. 5.
10.Pull out the cable and press home the cable clip (A)
on the ignition module. See fig. 8.
11. Fit the remaining parts on the saw. See respective
chapters.
Fig. 7
B
0,3mm
Air gap tool
A
D
Fig. 8
35Nm
G
English – 21