Turning The Answering System On/Off; Setting Your Outgoing Message (Greeting) - Uniden DCT 7488 SERIES Owner's Manual

Turning the Answering System On/Off

1) To turn the answering system on, press
off on the base when the phone is in standby mode or
from the Answer Setup menu (see page 61).
and the number of messages stored in
memory appear on the LCD. If the LCD flashes, then
there are new messages waiting for you.
2) To turn the answering system off, press
appears on the LCD.

Setting Your Outgoing Message (Greeting)

When you receive a call, the answering system automatically plays either the pre-
recorded message or your own greeting. To record your own greeting, or choose
between the two outgoing messages, refer to "Answering System Setup" on page 57.
The following message is pre-recorded: "Hello, no one is available to take your call.
Please leave a message after the tone."
Announce only feature
The announce only feature plays a pre-recorded outgoing message or your own personal
outgoing message, but it will not allow the caller to leave a message. To set announce
only, follow the steps on "Setting the Record Time" on page 59. If you want to use your
own greeting and you want to change your greeting to omit the prompt to leave a
message, refer to "Selecting Your Greeting (Base only)" on page 57.
The following message is pre-recorded:
"Hello, no one is available to take your call. Please call again."
w w w . u n i d e n . c o m
answer on/
answer on/off on the base.
T H E I N T E G R A T E D A N S W E R I N G D E V I C E [ 6 2 ]
note
When the answering
system is full, you will
hear "No Remaining
Time" and appears
on the LCD. You should
delete some messages
so that the system can
record new messages.