Table of Contents
Advertisement
Section 6: Hydraulic Plumbing
27975
Cylinder Plumbing (Independent Control)
Refer to Figure 6-8:
Make sure "ARM 1" , "ARM 2" , and "Deck Pivot" cylinder
hoses are plumbed to ports (SA, SB, SC, SD, SE, and
SF) at the solenoid valve block on the cutter frame as
shown.
35 Gallon
Reservoir
11/2/18
Table of Contents
Hydraulic Cylinder Plumbing for Independent Control Option
Figure 6-8
Filter
Deck Motor
Shut Off
Valve
Deck Motor Plumbing for Independent Control Option
Figure 6-9
RCP2660, RCPM2660, RCP3060 & RCPM3060: Parallel Arm Rotary Cutter: 316-111M:
Deck Motor Plumbing (Independent Control)
Refer to Figure 6-9:
The hydraulic motor on the deck is powered by a tractor
driven power take-off motor pump receiving fluid from a
35 gallon reservoir.
If cutter blades stall, an overpressure relief valve opens to
provide a return path to the reservoir. A "Deck Motor"
push button on the control stick is provided to allow the
operator to turn the motor on an off form the tractor seat.
Return oil is filter of particulates before dumping back into
the reservoir. Case drain is not filtered. Make certain the
hydraulic reservoir is full of oil and that the shut-off valve
is fully open before engaging tractor power take-off.
See Figure 6-7
Pressure Line
Motor Pump
Switch
Relief
Valve
See Figure 6-7
See Figure 6-7
Solenoid Control Box
Return Line
Case Drain
Deck Motor
27966
49
Advertisement
Table of Contents
