Table of Contents
Advertisement
Section 5: Optional Equipment
Kubota 3-Point Stabilizer Kit
Kubota 3-Point Stabilizer Kit . . . . . . . . . . . . . 316-325A
IMPORTANT: This optional stabilizer kit must be
used with RCP2660 & RCPM2660 Parallel Arm
Rotary Cutters attached to M126GX, M135GX,
M6-131, or M6-141 Kubota tractors. The Kubota
tractor can be damaged if this kit is not installed to
assist stabilizing the unit.
IMPORTANT: Do not use a Quick Hitch with Kubota
M126GX, M135GX, M6-131, or M6-141 tractors.
This kit is not designed to work with the Quick Hitch.
44
RCP2660, RCPM2660, RCP3060 & RCPM3060: Parallel Arm Rotary Cutter: 316-111M:
Table of Contents
Kubota 3-Point Stabilizer Kit For RCP(M)2660 Cutters only
Figure 5-4
Attach Lower Link Mounts
Refer to Figure 5-4:
6. If hooked to a tractor, unhook Parallel Arm Rotary
Cutter from the tractor. Refer to "Unhook Rotary
Cutter" on page 38.
7.
On the left-hand side, remove linchpin (#15) and
hitch pin (#14).
8. Attach left-hand lower link mount (#1) to the inside of
clevis plate (#18) with 5/8"-11 x 2" GR5 bolts (#3), flat
washers (#4), and lock nuts (#5). Draw lock nuts up
snug, do not tighten at this time.
9. Insert hitch pin (#14) through clevis plate (#18), link
mount (#1), spacer (#16), and bushing (#17).
Bushing (#17) should be in clevis plate hole.
10. Secure hitch pin (#14) with linchpin (#15).
11. Tighten hex lock nuts (#5) to the correct torque.
12. Repeat steps 7-11 to attach right-hand lower link
mount (#2) to the inside of clevis plate (#19).
39785
11/2/18
Advertisement
Table of Contents
