Table of Contents
Advertisement
Section 1: Assembly & Set-up
Breakaway Cylinder Hose Connections
Figure 1-10
Breakaway Cylinder
Refer to Figure 1-10:
The breakaway cylinder protects the Rotary Cutter from
damage when cutter deck or parallel arm contacts a solid
object while moving forward. It does not protect the cutter
while backing up. Always make certain the area behind
the cutter is clear before backing up. See Breakaway
Cylinder on page 46 for additional information.
IMPORTANT: A 1/2" bolt is installed for shipping
purposes only. This bolt must be remove before
connecting hydraulic hoses to the tractor.
1.
Remove 1/2" shipping bolt from cutter before
connecting hydraulic hoses. DO NOT reinstall
shipping bolt.
2. Attach breakaway hoses to a single duplex outlet on
the tractor as shown.
11/2/18
Table of Contents
Important:
Locate and Remove
1/2" Shipping Bolt
Before Connecting
Hydraulic Hoses.
12256
Weight Hanger Assembly
Refer to Figure 1-11:
There are six different weight hangers that can be
attached to the reservoir. One of the six must be installed
for operation. See "Bolt-on Weight Hangers" on page
42 for detailed description of available weight hangers.
1.
2. Attach manual storage container (#9) to the front side
3. Insert weight retainer pin (#2) through holes in weight
RCP2660, RCPM2660, RCP3060 & RCPM3060: Parallel Arm Rotary Cutter: 316-111M:
Case/International Harvest Weight Hanger Only:
Locate L-shaped spacer between weight hanger
side plate and hydraulic reservoir.
Weight Hanger Installation
Figure 1-11
NOTE: Case/International Harvest weight hanger
includes an L-shaped spacer. Be sure to locate this
spacer between the weight hanger side plate and
hydraulic reservoir tank in assembly.
Attach weight hanger (#1) to reservoir with fourteen
1/2"-13 x 1 1/4" GR5 cap screws (#3) and hex flange
lock nuts (#3). Tighten lock nuts to the correct torque.
of the reservoir with two 1/4"-20 x 1 1/4" GR5 cap
screws (#4), flat washers (#7), and hex nylock
nuts (#6). Tighten nylock nuts to the correct torque.
hanger and secure with hairpin cotters (#8).
30029
19
Advertisement
Table of Contents
