Land Pride RCP2660 Operator's Manual page 52

Section 6: Hydraulic Plumbing
35 Gallon
Reservoir
Deck Motor Plumbing (Solenoid control)
Refer to Figure 6-6:
The hydraulic motor on the deck is powered by a tractor
driven power take-off motor pump receiving fluid from the
35 gallon reservoir.
If cutter blades stall, an overpressure relief valve opens to
return oil to the reservoir. All return oil is filtered of
particulates before dumping into the reservoir. Case
drain is not filtered. Make certain the hydraulic reservoir
is full of oil and that the shut-off valve is fully open before
engaging tractor power take-off.
35 Gallon
Reservoir
48
RCP2660, RCPM2660, RCP3060 & RCPM3060: Parallel Arm Rotary Cutter: 316-111M:
Table of Contents
Filter
Relief
Valve
Shut Off
Valve
Deck Motor Plumbing for Tractor and Solenoid Control Options
Filter
Shut Off
Valve
Cylinder Pump Plumbing for Independent Control Option
Pressure Line
Motor Pump
Figure 6-6
Independent Control
Refer to "Independent Control" on page 21 for
assembly and set-up instructions.
Cylinder Pump Plumbing
Refer to Figure 6-7:
The oil is delivered to the solenoid valve block by a tractor
driven power take-off cylinder pump receiving fluid from
the 35 gallon reservoir. Excess oil is diverted back to the
reservoir through an overpressure relief valve. Return oil
is filter of particulates before dumping back into the
reservoir. Make certain the hydraulic reservoir shut-off
valve is fully open before engaging power take-off.
See Figure 6-9
Return Line
Pressure
Overpressure
Relief Valve
Cylinder Pump
See
Figure 6-9
Figure 6-7
Return Line
Case Drain
Deck Motor
Solenoid with Float
Control Capabilities
27968
27967
11/2/18