Cisco ASR 1002-F Overview And Installation page 3

Cisco ASR 1002-F Router Overview and Installation
Figure 2: Cisco ASR 1002-F Router With AC Power Supplies Rear View
1 Chassis ESD socket
2 AC power supply slot 0 label
3 AC power supply On (|)/Off (O) switch
4 AC power supply LEDs
Note
On the side of the Cisco ASR 1002-F Router there is an eUSB panel door and the grounding lug as shown in
the "Cisco ASR 1002-F Router Chassis Ground Lug Location and eUSB Side Panel Door" figure in the
Attaching a Chassis Ground Connection section. This panel door must not be opened. There is a Do Not
Tamper label on the panel door. Do not remove the label. If there is a problem with the eUSB flash card, then
the chassis should be returned.
The follwing image shows the rear of the Cisco ASR 1002-F Router with DC power supplies installed.
Figure 3: Cisco ASR 1002-F Router With DC Power Supplies Rear View
1 Chassis ESD socket
2 DC power supply slot 0 label
3 DC power supply Standby/On (|) switch
5 Fan
6 Captive installation screw
7 AC power supply slot 1 label
8 AC power inlet
6 Captive installation screw
7 DC power supply slot 1 label
8 Ground lead
Cisco ASR 1002-F Router Overview and Installation
Rear View
3