Cisco ASR 1002-F Overview And Installation page 14

Equipment Shelf or Tabletop Installation
The chassis in the above image does not represent the Cisco ASR 1002-F Router. This is only an example of
Note
how to lift a Cisco chassis.
Step 3
Attach the front rack-mount brackets. Locate the threaded holes in the front sides of the chassis (first holes beyond the
vent holes) and use the package of black screws that shipped with the chassis.
Step 4
Align the front rack-mount bracket to one side of the chassis.
Step 5 Insert and tighten the screws on one side.
Step 6
Repeat Step 4 through Step 5 on the other side of the chassis. Use all the screws to secure the rack-mount brackets to the
chassis.
The chassis rack-mount brackets must be installed first so that you can attach the cable-management brackets
Note
to the chassis rack-mount brackets after the chassis is installed in the rack.
Step 7
Gather the two cable-management brackets and screws that shipped with your chassis. The following image shows
cable-management brackets attached on the front of the Cisco ASR 1002-F Router.
Make certain that the cable-management bracket "U" feature device has the open end pointing upwards when
Note
you attach it to the chassis
Figure 11: Attaching the Cable-Management Brackets to the Cisco ASR 1002-F Router
1 Cable-management bracket top screw hole and bottom screw hole
2 Cable-management bracket "U" feature
Step 8
Screw the cable-management brackets to each side of the rack-mount brackets already attached to the chassis. Use two
screws for each cable-management bracket.
Step 9
Check that all the screws are securely tightened.
What to do next
Go to the
Cisco ASR 1002-F Router Overview and Installation
14
Attaching a Chassis Ground Connection, on page 24
Cisco ASR 1002-F Router Overview and Installation
3 Chassis front rack-mount bracket
— —
to continue the installation.