Guidelines For An Equipment Shelf Or Tabletop Installation - Cisco ASR 1002-F Overview And Installation

Guidelines for an Equipment Shelf or Tabletop Installation

• Provide an adequate chassis ground (earth) connection for your router chassis.
In addition to the preceding guidelines, review the precautions for avoiding excessive temperature conditions
in the
The following table provides the Cisco ASR 1002-F Router dimensions and weight information.
Table 6: Cisco ASR 1002-F Router Dimensions and Weight
Cisco ASR 1002-F
Depth
Height
Width
Weight
Guidelines for an Equipment Shelf or Tabletop Installation
The chassis should already be in the area where you will install it. If you have not determined where to install
your chassis, see the
information about site considerations.
If you are not rack-mounting your Cisco ASR 1000 series chassis, place it on a sturdy equipment shelf or
tabletop.
When installing the Cisco ASR 1002-F Router on an equipment shelf or tabletop, ensure that the surface is
clean and that you have considered the following:
• The Cisco ASR 1002-F Router requires at least 3 inches (7.62 cm) of clearance at the inlet and exhaust
• The Cisco ASR 1002-F Router should be installed off the floor. Dust that accumulates on the floor is
• There must be approximately 19 inches (48.3 cm) of clearance at the front and rear of the chassis to
• The Cisco ASR 1002-F Router needs adequate ventilation. Do not install it in an enclosed cabinet where
• Have the cable-management bracket available if you plan to install it on the front of the chassis.
• An adequate chassis ground (earth) connection exists for your router chassis
• Always follow proper lifting practices as outlined in the next section, when handling the chassis.
Cisco ASR 1002-F Router Overview and Installation
12
"Site Environmental Requirements" section on page 5-9
Dimensions
22.50 in. (57.15 cm)(including card handles, cable-management brackets, power supply
handles
3.47 in. (8.813 cm)—2RU rack-mount per EIA RS-310 standard
17.25 in. (43.815 cm)—19-inch rack-mount
40 lb (18.143 k)—fully configured
"Cisco ASR 1000 Series Routers Component Overview" section on page 2-1
vents (the front and rear sides of the chassis).
drawn into the interior of the router by the cooling fans. Excessive dust inside the router can cause
overtemperature conditions and component failures
.
install and replace FRUs, or to access network cables and equipment.
ventilation is inadequate.
(see the Attaching a Chassis Ground Connection, on page
Cisco ASR 1002-F Router Overview and Installation
.
24).
for