Lenovo ThinkSystem SR645 Setup Manual page 126

• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DY1RaWHYM4xDloAwuBQHR0
• Youku:
http://list.youku.com/albumlist/show/id_52339628
Procedure
Step 1. Touch the static-protective package that contains the new backplane to any unpainted surface on
the outside of the server. Then, take the new backplane out of the package and place it on a static-
protective surface.
Step 2. Install the 7mm drive backplane at the bottom.
Figure 43. 7mm drive backplane installation (bottom)
a. Align the pin on the cage and slightly slide the backplane into the cage until it is fully seated.
b. Install the screw as shown.
Step 3. Install the 7mm drive backplane on the top.
Figure 44. 7mm drive backplane installation (top)
a. Put the backplane down on the cage as shown.
b. Install the two screws to secure the backplane in place
ThinkSystem SR645 Setup Guide
122