Advertisement
loosely fasten with 1/4-20 x .75 screw (item 13)
and nyloc nut (item 15). Install hardware (items
13 and 15) to right hand side.
11. Install the left and right posts (item 3) on the
outside of the rear bow (item 2) and fasten
loosely with the hardware shown in Figure 4.
12. Fasten the left and right braces to the posts as
shown in Figure 5.
FIGURE 5
13. Insert the posts into the canopy mounts as
shown in Figure 5. If posts do not insert easily
into the mounts, file the inside of the mount
bracket and re-insert into the ends of the posts.
14. On right side, use a 9/32" drill bit to drill a hole
though the canopy mount and post as shown in
Figure 6.
FIGURE 6
15. Install the hitch pin (item 18) to secure the post
to the canopy mount.
16. Tighten all hardware.
17. Install the vinyl canopy cover (item 7) over the
front bow assembly. Pull the back of the canopy
over the rear bow.
18. Re-install the hydro fan cover, tip the seat back
and put the wires back on the spark plugs.
Important: Remove the entire sunshade kit
before transporting the unit in an open truck or
trailer or damage may occur.
WARNING
POTENTIAL HAZARD
♦ The sunshade kit does not provide roll over
protection.
WHAT CAN HAPPEN
♦ A roll over of the unit could cause serious
injury or death.
HOW TO AVOID THE HAZARD
♦ Drive slowly and carefully.
♦ Read and follow slope operation instructions
and warnings in the mower Operator's
manual.
Page 3 of 3
Part #109-6387 Rev. B
Kit # 109-6250
Advertisement
