Launch Sensorbox X-431 GDS Manual page 4

LAUNCH
Precaution on Operation
The appliance is a sophisticated electronic device, never have it
clashed when in use.
Main unit screen may flash at the moment of engine ignition, which is
normal.
You may unplug the main unit if the program can not be actuated or
confused screen occurs. Plug again to continue the operation.
Make sure the appliance is properly connected to the DLC to avoid
communication interruptions.
During operation, keep the screen upward and leveled.
Be careful when plugging and unplugging the main cable and
diagnostic connector. Tighten the screw before operation to avoid
unexpected disconnecting and/or damage to the port.
Handle with care. Avoid collision. Unplug the power after operation.
Do not insert or pull the GDS card when the main unit is powered on.
After the operation, the stylus shall be inserted into the hole on the
back of the main unit, and put away the cable and connector, etc
accessories to the box to avoid the lost.
Unplug the power cable by holding the connector, not the cable itself
X431 GDS Sensorbox Manual
iv