Table of Contents
Advertisement
Installation Guide
Programming Overview
Program mode allows you to adjust the settings and options of your system.
Your system has been intelligently designed by installers with years of experience. The system's default
settings do not require any program changes in most cases. However, this system does incorporate a highly
advanced programming system that includes 2 menus with numerous options and settings that can be easily
adjusted for custom installations and applications.
User Settings - Page 8.
This program menu contains settings that adjust the way the system operates for the user
Alarm Settings - Page 9.
This menu controls addition channel outputs and output timing.
Entering Program Mode
To Enter Program Mode
1) Make sure ignition is in the off position.
2) Within three seconds turn the key ON - OFF - ON - OFF - ON. Leave in the "ON" position.
3) Press and release the Program Button one time.
4) Park lights will come and the siren will chirp to confirm entering Program Mode.
5) Select Desired Program Menu by the following:
Press Button #1
Lock
Press Button #2
Unlock
6) The selected mode will be confirmed by a siren chirp and one park light flash.
7) The Program Menu may be changed at any time by pressing the transmitter buttons as above, this
allows the installer to change a setting from one menu, then quickly jump to another menu and
change another setting without re-entering the Program Mode.
8) Program Mode will be exited if there is no activity for 30 second or if the key is turned to the "Off"
position. This will be confirmed by one long siren chirp and park light flash.
Note: If unit does not enter Program Mode, turn ignition off for 5 seconds and repeat steps 1-4.
** The ignition wire(Yellow) MUST be connected to the vehicle's ignition wire. If it is not connected
it will not be possible to enter the Program Modes.
Changing the Programmable Settings
To Select and Change A Program Setting:
1) Enter Program Mode.
2) Select the desired Program Menu. (See pages 8&9)
3) Press & release the Program Button the correct number of times to select the desired Program
Setting(as listed on pages (8&9). The park lights will flash and the siren will chirp to indicate the current
setting that is selected.
4) Press and hold the Program Button until the parking lights / siren confirm the selected setting. The
park lights will flash and the siren will chirp to indicate the option selected within the setting.
5) Turn the ignition key "Off" to exit Program Mode.
NOTE: This procedure is listed in detail below each program setting on pages 8&9 of this manual.
SYSTEM RESET
STEP 1 - Within three seconds turn the key ON-OFF-ON-OFF-ON (Leaving the Key ON).
STEP 2 - Press and release the Program Button.
STEP 3 - Park Lights will come ON
STEP 4 - Press the Program Button a second time and hold for 8 seconds until the park lights flash 3
times and siren chirps 3 times.
System is now re-set to factory defaults.
NOTE: Reset to defaults does not delete the transmitters from memory.
PROGRAMMING OVERVIEW
User Options
Alarm Settings
Page 8.
Page 9.
7
Advertisement
Table of Contents
